How to Assign an IP Address to Cisco Wireless Bridge Using the CLI

	Home \| Net Issues \| Net How To \| Wireless \| Case Studies \| Articles \| Forums \| Services \| Donations \| Careers \| About Us \| Contact Us\|

(main)How to Assign an IP Address to Wireless Bridge Using the CLI

When you assign an IP address to the access point/bridge using the CLI, you must assign the address to a bridge virtual interface (BVI) that it creates automatically. To assign an IP address to AP, please follow these steps:

1. Run privileged EXEC mode and then the following commands.
2. configure terminal
3. interface bvi1
4. ip address address mask
5. end
6. copy running-config startup-config

Note: After you have configured the access point/bridge IP address, you can use your Internet browser to access the unit’s graphical user interface (GUI).

Post your questions, comments, feedbacks and suggestions

Contact a consultant